www.LockState.com
CAUTION: Do not keep the keys in the safe.
1. OPENING THE SAFE THE FIRST TIME
Use a screw driver to pry off the oval-shaped plastic cover situated to the right of the keypad
(see “(a)” in diagram 1), exposing the keyhole underneath. Insert the key into the keyhole
and turn it counter-clockwise. Now, leave the key in the turned position and turn the knob
clockwise to retract the locking bolts. You can follow these steps to manually open your safe
anytime.
2. INSTALLING THE BATTERIES
The safe requires 4 size ‘AA’ (1.5V) batteries. Remove the battery cover (on the back of the
safe door) and install the batteries into the battery compartment. Make sure the batteries are
fitted with the correct corresponding polarity. The display will scan the status of the electronic
lock system automatically and will read ‘good’ (see (c) in diagram 1). Use of alkaline
batteries is recommended.
3. OPENING THE SAFE AFTER INSTALLING THE BATTERIES
A. To open the door of the safe, press the ‘START’ button (see (d) in diagram 1), and the
display will show ‘--------’.
B. Then input one of the two sets of factory-preset codes: 0,0,0,0 (user code) or
8,8,8,8 (master code) immediately and confirm by again pressing the ‘START’ button. You
will hear a beeping sound as the display reads ‘OPEN’.
C. Turn the knob to retract the locking bolts and open the safe (NOTE: you must turn the
knob within approximately 4 seconds or you will need to start the process again)
NOTE: If you do not want the display to show your codes as you enter them press the
‘START’ button twice at the beginning of the process.
4. PROGRAMMING THE CODES
The safe can be programmed with two sets of codes: (1)One Master Code and (2)One User
Code. For the security of your valuables, immediately after installing the batteries, you
should program two new sets codes to replace the two sets of factory-preset codes.
Programming the master code
A. With the door of the safe open, press the red button located on the inside of the door
near the hinge (see ‘(b)’ in diagram 2) then press the ‘START’ button. The display will read
‘oLd CodE’.
B. Now input the original master code (factory preset code: 8,8,8,8) and press the ‘START’
button. The display will read ‘SET’.
C. Enter the new master code (from 3 to 8 digits) and confirm by pressing the ‘START’
button. The display will show ‘rE-InPUT’.
D. Now enter your new master code again and confirm by pressing the ‘START’ button.
After hearing a series of beeps the display will read ‘IN’ and your new master code indicating
that the new master code is confirmed.
OPERATING INSTRUCTION for LockState Safe LS-20ED
Thank you for purchasing the Lockstate LS-20ED closet safe. This safe will install easily
on floors, walls or in closets. This easy quick-start quide will help you through the
installation and programming process.
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels